User Manual

30
DVA K5 Code 420120232 REV.1.0
English
INPUT OUTPUT AND CONTROL SECTION
2. LINK AUDIO OUTPUT
Balanced XLR output, allowing to send the input audio signal to
another amplied speaker.
1. BALANCED AUDIO INPUT
Audio input for a cable equipped with a
balanced XLR connector.
LED TYPE SPEAKER
SWITCH-ON
NORMAL
OPERATION
GENERIC
WARNING
STOP DUE TO
SPEAKER MALFUNCTION
LIMITER OFF OFF, IT STARTS
BLINKING ONLY
IN DISTORSION
CASE
TEMPORARY
BLINKING
ONGOING CYCLIC BLINKING
SIGNAL OFF BLINKING WITH
SIGNAL
NORMAL INPUT
AUDIO INDICA-
TION
OFF
MUTE/
PROT
ON FOR A
FEW SECONDS
OFF TEMPORARY
BLINKING
STEADILY ON
READY OFF STEADILY ON STEADILY ON OFF
3. AUDIO INPUT SENSITIVITY
It allows to vary the input sensitivity. Before turning on the unit,
make sure that the Audio Input Sensitivity is turned to 0 dB.
5. LEDs (Limiter, Signal, Mute/Prot, Ready)
During normal speaker operation with audio input signal, the Ready LED is steadily on, the Signal LED blinks
indicating the signal presence.
LEDs table
6. "SERVICE DATA" USB PORT
The type B mini-USB B port allows to update the product rmware. For further information, please refer to
the Web site (see DOWNLOADS section and )
4. DSP CONTROL ROTARY ENCODERS FOR IN LINE-ARRAY SETTING
The “SPEAKER COUPLING” rotary encoder and the “HIGH FREQUENCY
COMPENSATION” rotary encoder allow to optimise the sound
behaviour of the K5 modules congured in a line-array. Also refer to
paragraph “IN LINE-ARRAY CONFIGURATION AND OPTIMISATION”.