User Manual

12
ENGLISH
4. ROTATING HORN
Loudspeaker allows to maintain the same coverage angle by featuring a rotating horn.
The speakers are always supplied by the manufacturer with the horn positioned horizontal by
default at 90° for LVX series.
If you wish to change the coverage angle (Fig. 1):
- unscrew the fixing screws of the grille
- remove the front protective grille by slightly pressing on one side and taking the grille off
the recessed slots
- unscrew the fixing screws of the horn
- rotate the horn in the desired position (the horn should never be removed from the
driver!)
- tighten the fixing screws of the horn
- put the grille back in the recessed slots and tighten the screws of the grille.
5. LOUDSPEAKER INSTALLATION
WARNING
Make sure that the loudspeaker is securely installed in a stable position to avoid any
injuries or damages to persons or property.
For safety reasons do not place one loudspeaker on top of another without proper fastening
systems. Before hanging the loudspeaker check all the components for damages, deformations,
missing or damaged parts that may compromise safety during installation.
If you use the loudspeakers outdoors avoid places that are exposed to bad weather.
The loudspeaker has the following mounting options:
- bookshelf
- floor (monitor)
- on speaker stands
- suspended with support rails or brackets supplied by the manufacturer
WARNING
Never use the handles to hang the speaker!
WARNING
To hang the loudspeaker use only one eyebolt for each hanging point
The hanging points are of M8 threads for LVX 8 / LVX 10 and M10 threads for
LVX 12 / LVX 15
Do not unscrew both bolts recessed in the housing!
NO!
YES!
YES!