User Manual

INGENIA IG3T Cod. 420120239 REV. 1.1

4. INSTALLATION EXAMPLES

• To use 2 stacked speakers, you need the optional LP-IG accessory. For further information,

please refer to the instructions of this accessory.

• Always check that the handles, allowing the infra-red communication, are not obstructed;

never cover them and remove any dust or dirt deposits.

• No installation other than that shown here is allowed.

INSTALLATION ON STAND

INSTALLATION ON SUBWOOFER WITH POLE

INSTALLATION ON SUBWOOFER

1 INGENIA IG3T can be installed in both stereo and mono conguration on an

optional standard tripod stand, with a pole having a diameter of 35 mm. The

maximum permissible height between the base of the speaker and the oor is 120

cm (47.25 in).

It is possible to use a single speaker mounted on 35 mm diameter pole. Additional

mechanical xing, or xing with straps, is required to properly secure the

installation. The maximum permissible height between the base of the speaker

and the oor is 120 cm (47.25 in). Once the installation is completed, follow the

subwoofer conguration instructions in the SUBWOOFER MATCHING section.

ATTENTION!

• Use an appropriately sized stand with the central foot forward to

ensure proper stability.

• When “Stacked” on a tripode stand, the INGENIA IG3T cannot be

mounted in the conguration with 2 speakers stacked, but only

in a single speaker conguration, for safety reasons.

Using the GSA-IG accessory during the installation, you can use the speakers (1 o

2) mounted on subwoofer. This allows to get an extremely compact system, with

great output power over the whole range of sound frequencies, installed on the

ground. Additional mechanical xing, or xing with straps, is required to properly

secure the installation. Once the installation is completed, follow the subwoofer

conguration instructions in the SUBWOOFER MATCHING section.

English