User Manual
52
INGENIA IG3T Cod. 420120239 REV. 1.1
ACCESSING THE MENUS
The push rotary encoder (3) allows the user both to perform a selection by turning it and to conrm a selection by
pressing it. These operations allow to navigate the menus and sub-menus available on the OLED display (2). Inside
the menus and sub-menus, turning the encoder to the right or to the left also allows to increase or decrease the
selected values.
The initial screen at switch-off displays the IG3T level and gain. All settings can be protected by a password.
At switch-on, the IG3T display shows the initial screen, indicating the GAIN and the signal level,
simulating a VU METER.
• Once manually performed, the settings remain stored even after the speaker has
been switched off.
• After approximately one minute has elapsed since the last selection or
conrmation, the system returns to the initial screen (IG3T level/gain). The user
can also return to the initial screen from any point, in 2 ways:
3. CONTROL PANEL AND SETTING MENUS
SELECT / DECREASECONFIRM
SELECT / INCREASE
• If the speakers are 2 and installed in a stacked conguration, the system detects
them and automatically assigns the control of both to the amplier which is being
operated. This allows to perform an adjustment that will apply and can be stored
for the whole system, irrespective of the rotary that is being operated (mirroring
OLED) .
a. by selecting and conrming, when existing in a sub-menu, the symbol
b. by holding the push rotary encoder pressed for a few seconds
Push rotary encoder use examples
English