User Manual

u
s
e
r m
a
n
u
a
l
En
g
l
i
sh
English
7
E
n
g
l
i
sh
English
u
s
e
r
m
a
n
u
a
l
8
CROMO 10
The CROMO 10 bi-amped active speaker is equipped
with digital amplifier delivering 140W RMS for the bass
section and 40W RMS for the high frequency section.
The 2-way bi-amplified speaker is equipped with 10”
woofer (1,5” voice coil) and 1” Neodymium driver (1” voice
coil) loaded with 90°/70°x60°asymmetric horn.
The speaker is made of plastic material, and is provided
with a top handle, rubber coated , which eases
transportation.
In the bottom of the box there is a standard pole mount cup
(D36mm).
The speaker has been designed to be used also as stage
monitor (45° angled).
C
r
o
m
o
WOOFER
DRIVER
CROMO 10
O 36mm PEDESTAL/
BRACKET HOUSING
AMPLIFIER
PLANE 45°
PLANE 45°
HANDLE
REFLEX HOLES
REFLEX HOLES
CROMO 12
The CROMO 12 bi-amped active speaker is equipped
with digital amplifier delivering 240W RMS for the bass
section and 60W RMS for the high frequency section.
The 2-way bi-amplified speaker is equipped with 12”
woofer (2” voice coil) and 1” compression driver (1.5”
voice coil) loaded with 90°/70°x60°asymmetric horn.
The speaker is made of plastic material, and is provided
with a top handle, rubber coated , which eases
transportation.
In the bottom of the box there is a standard pole mount
cup (D36mm).
The speaker has been designed to be used also as stage
monitor (45° angled).
C
r
o
m
o
CROMO 12
WOOFER
DRIVER
PLANE 45°
PLANE 45°
REFLEX HOLES
REFLEX HOLES
O 36mm PEDESTAL/
BRACKET HOUSING
HANDLE
AMPLIFIER
COMMANDSAND FUNCTIONS
AMPLIFIER PANEL (Ref. page 23)
1) “ Inputs” CONNECTORS
“Ready” INDICATOR LIGHT
“VOLUME” CONTROL
“Sensitivity” SWITCH
POWER SWITCH “POWER”
7) FUSE CARRIER “FUSE”
POWER CABLE SOCKET “MAINS”
These balanced inputs can be used to connect balanced or unbalanced
microphones or audio sources at line level (0dB) (eg. preamplifier, mixer, recorder,
CD player, musical instrument, ...).
The balanced connector is connected in parallel and can be used to send the audio
signal to other amplified speakers, recorders or supplementary amplifiers.
READY
The knob regulates the speaker´s volume.
This control does not affect the output “LINK” levels.
Position the switch in LINE to use a line level source (0 dB) or MIC to use a
microphone.
This switch can be used to switch the speaker on and off.
Mains fuse housing. Replace only with identical value!
Used for connecting the power cable supplied.
2) “Limiter” INDICATOR LIGHT
5)
6)
8)
This indicator shows red to indicate that the internal limiter circuit has tripped.
This prevents amplifier distortion and protects the speakers against overloads.
The “ ” indicator light comes on green to indicate that the amplifier is switched
on and it is working properly.
3)
4)
During normal operation the LED serves as Vu-meter
monitoring the audio level riproduced.