E5 HLC6 6 Channel Line Output Converter
We would like to congratulate you on your purchase of the E5 HLC6; a 6 channel, high-performance line output converter. The E5 HLC6 will accept two, four, or six channels of Speaker-level signal from a factory-installed amplifier or Source unit and convert it into a high-quality, low-noise pre-amp signal. Therefore the E5 HLC6 will allow you to use your factory installed source unit but give you the ability to add any high performance aftermarket amplifier and processor.
FRONT PANEL CONTROLS ELECTRICAL INSTALLATION 4 3 RCA Connectors Factory Installed Radio 5 SUB REMOTE LEVEL SUB REAR ISO SHORT 6 Rear Speakers AMPLIF I ER Front Speakers AMPLIF I ER Subwoofers AMPLIF I ER Rear Speakers FRONT OUTPUT SUB 220 POWER AMPLIF I ER Summed REAR Summed Separate Separate SIX CHANNEL LINE OUTPUT CONVERTER REAR OUTPUT VOLUME SUB OUTPUT VOLUME FRONT OUTPUT VOLUME Speaker Level -4 Channel RCA Connectors Factory Installed Radio 2 1 SUB REMOTE LEVEL SUB 220
BLOCK DIAGRAM SPECIFICATIONS All specifications are measured at 14.4VDC >Maximum speaker-level input 60 watts @ 4 ohm >Maximum output level 9.5 V rms >Output gain +/-12dB >Frequency response 10Hz-25kHz >T otal harmonic distortion 0.
