Instruction Manual

( WDX1KG2 - WDX2KG2 - WDX3KG2 - WDX5KG2 )

The WDX1KG2, WDX2KG2, WDX3KG2 and WDX5KG2 are equipped with a

variable 24db slope Lowpass crossover network and a 24db slope subsonic ﬁlter.

The mono amps also feature a Selectable Bass Boost EQ is set at 45Hz.

In some subwoofer enclosure installations it may necessary to use the Phase Shift

feature. The Phase Shift button sets the Subwoofer signal between 0 degree

setting and 180 degree settings. This will also allow you to ﬁne tune the subwoofer

enclosure depending on vehicle location.

ADJUSTMENTS AND SETTINGS

G2 G2

Before connecting the remote, it will be necessary to ﬁnd a mounting location that

will be easy to access for adjustment. Once you select your mounting location, your

mounting location, you will need to run the control wire from the remote to

the remote to the ampliﬁer. To avoid possibility of induced noise from the car’s

electrical system ( i.e. popping noises or engine noise ), run the cable from the

remote to the ampliﬁer away from the car’s electrical wiring.

MOUNTING LOCATION

MONOBLOCK AMPLIFIER

2KG2

2000 WATT

REMOTE BASS CONTROL MODULE