Instruction Manual
Low Impedance Stability
WDX400.4G2 - 2 Ohm Stereo (4 Channel)
WDX300.4G2 - 2 Ohm Stereo (4 Channel)
WDX800.4G2 - 2 Ohm Stereo (4 Channel)
WDX1KG2 - 1 Ohm Mono
WDX2KG2 - 1 Ohm Mono
WDX3KG2 - 1 Ohm Mono
WDX5KG2 - 1 Ohm Mono
MONOBLOCK AMPLIFIER
4 CHANNEL AMPLIFIER
G2
G2
G2
G2
11 4
FEATURES AND BENEFITS
4 Channel: [ WDX300.4G2, WDX400.4G2, WDX800.4G2 ]
The WDX300.4G2, WDX400.4G2 and WDX800.4G2 amplifier allow you to select the
crossover mode (High-Pass, Full Range or Low Pass / Band Pass) and desired crossover
point for channels 1-2 and 3-4.
For example if you wish to use a 2-way loud speaker on channels 1-2, simply set the
crossover switch to HPF and adjust the frequency se�ng to the desired HPF se�ng to
block out any unwanted low frequencies.
If you wish to run a subwoofer on channels 3-4, simply set the crossover switch to LP/BP.
You must adjust the HPF frequency se�ng to 50Hz and the LPF frequency se�ng to the
desired Low Pass se�ng to block out any unwanted high frequencies.
If you wish to run a component midrange on either channels 1-2 or 3-4 set the crossover
switch to LP/BP. Then use both HPF and LPF frequency controls to create the desired
band pass frequency range.
Adjust HP to desired frequency
Adjust HP to desired frequency
Example
Example
Adjust LP to desired frequency
Adjust LP to desired frequency
HP must be set to 50Hz
Example
HP LP
BP
BUILT-IN CROSSOVER