Instruction Manual

SAFETY PRECAUTIONS
G2 G2
13
2
PROBLEM LOOK FOR SOLUTION
No Output Blown fuse Replace
Bad RCA Cable(s) Replace
+12V at power terminal Check connection
+12V at remote terminal Check connection
Grounding point are clean and tight Check for ground w/meter
Head unit’s fader not in center position Set to center position
Master and slave settings Confirm correct setting
Low Output Check level adjustments
Bad RCA cable(s) Replace
Improper level matching Re-adjust
Master and slave settings Confirm correct settings
Engine Noise Grounding points are clean and tight Check for ground w/meter
Ground all components at same point Ground at same point
Try different grounding point Change for better ground
Bad RCA cable(s) Replace
Use high quality shielded RCA cables Rejects inducted noise
Low vehicle charging system and/or battery Fix and/or replace
Red protection L.E.D. illumintaed Speaker short Check speakers connection
for short circuit
Speaker grounding out Make sure speaker wires do
not touch chassis ground
Impedance too low Check speaker impedance
Overheating Check mounting location for
adequate air circulation.
Speaker impedance too low
TROUBLE SHOOTING THE SYSTEM