Owner`s manual
12
Specifications
■ General Specifications
0 dBu=0.775 Vrms, Half Power=1/2 Power Output Level (Rated Power)
Specifications and descriptions in this owner’s manual are for information purposes only. Yamaha Corp. reserves the right to change or modify products or spec-
ifications at any time without prior notice. Since specifications, equipment or options may not be the same in every locale, please check with your Yamaha
dealer.
European models
Purchaser/User Information specified in EN55103-1 and EN55103-2.
Inrush Current: 32A (P7000S, P5000S)/65A (P3500S)/55A (P2500S)
Conforms to Environments: E1, E2, E3 and E4
P7000S P5000S P3500S P2500S
Power Output Level (Rated Power) 8 Ω/STEREO 750 W
× 2 525 W × 2 390 W × 2 275 W × 2
1 kHz 4 Ω/STEREO 1100 W × 2 750 W × 2 590 W × 2 390 W × 2
THD + N = 1% 8 Ω/BRIDGE 2200 W × 1 1500 W × 1 1180 W × 1 780 W × 1
8 Ω/STEREO 700 W × 2
650 W
×
2 (European Model)
500 W × 2 350 W × 2 250 W × 2
20 Hz – 20 kHz 4 Ω/STEREO 950 W × 2 700 W × 2 450 W × 2 310 W × 2
THD + N = 0.1% 8 Ω/BRIDGE 1900 W × 1 1400 W × 1 900 W × 1 620 W × 1
1 kHz 2 Ω/STEREO 1600 W × 2 1300 W × 2 1000 W × 2 650 W × 2
20 ms non-clip 4 Ω/BRIDGE 3200 W × 1 2600 W × 1 2000 W × 1 1300 W × 1
Power Bandwidth Half Power 10 Hz – 40 kHz (THD + N = 0.5 %)
Total Harmonic Distortion (THD + N) 4 Ω – 8 Ω/STEREO
0.1 %
20 Hz – 20 kHz, Half Power 8 Ω/BRIDGE
Frequency Response RL = 8 Ω, Po = 1 W 0 dB, +0.5 dB, –1 dB f = 20 Hz – 50 kHz
Intermodulation distortion (IMD) 4 Ω – 8 Ω/STEREO
0.1 %
60 Hz:7 kHz, 4:1, Half Power 8 Ω/BRIDGE
Channel Separation Half Power RL = 8 Ω 1 kHz
70 dB
Vol. max input 600 Ω shunt
Residual Noise Vol. min. 20 Hz – 20 kHz (DIN AUDIO)
–70 dBu
SN Ratio 20 Hz – 20 kHz (DIN AUDIO) 104 dB 103 dB 102 dB 100 dB
Damping Factor RL = 8 Ω, 1 kHz
350 200
Sensitivity (Vol. max.) Rated Power 8 Ω +8 dBu +6 dBu +4 dBu +3 dBu
Voltage Gain (Vol. max.) 32.1 dB
Input Impedance 30 kΩ/balanced, 15 kΩ/unbalanced
Controls Front Panel POWER switch (Push on/Push off)
Two 31-step Volume control knobs (one per ch)
Rear Panel MODE switch (STEREO/PARALLEL/BRIDGE)
Two FILTER switches (SUBWOOFER/LOW CUT/OFF)
Two fc knobs (25 to 150 Hz)
YS Processing switch (ON/OFF)
Connectors INPUT XLR-3-31 jacks (one per ch)
1/4-inch TRS phone jacks (one per ch)
OUTPUT Speakon jacks (one per ch)
5-way binding posts
1/4-inch phone jacks (one per ch)
Indicators POWER × 1 (Green)
PROTECTION
× 1 (Red)
TEMP
× 1 (Red) (heatsink temp 85°C)
CLIP
× 2 (Red)
SIGNAL × 2 (Green)
YS Processing
× 1 (Yellow)
Load protection POWER switch ON/OFF muting
DC-fault power supply
shutdown
DC detection
Amp. protection
Temp. detection (heat sink temp 90°C), VI limiter (RL 1 Ω)
Limiter
Comp: THD 0.5 %
Cooling Dual variable-speed fan Single variable-speed fan
Power Requirements United States & Canada 120 V, 60 Hz
Europe 230 V, 50 Hz
Australia 240 V, 50 Hz
Power Consumption Idling 35 W 35 W 30 W 25 W
1/8 output power, 4 Ω 700 W 550 W 450 W 320 W
Maximum output, 4 Ω 4000 W 3000 W 2000 W 1600 W
Dimensions (W
× H × D) 480 × 88 × 456 mm
Weight 12 kg 12 kg 15 kg 14 kg
Included Accessories Security cover (with a hex wrench), Owner’s Manual
≤
≤
≥
≤
≥ ≥
≥
≥
≤
≥