PROFESSIONAL AUDIO SYSTEM SUBTREX OPERATING MANUAL Ver. SUBTREX-EN-1.0 LSS Advanced Speaker Systems Via On. Longo 53-89024 Polistena (RC) ITALY Tel (39) 966 9321299 – Fax (39) 966 933007 Email: info@lss.it - Internet: www.lss.
SUBTREX______________________________________________________________________________ NOTICE: LSS products are manufactured for use according to proper procedures by a qualified operator and only for the purposes described in this manual. The following conventions are used to indicate and classify precautions in this manual. Always heed the information provided with them. Failure to heed precautions can result in injury to people or damage to property. © LSS, 2014 All rights reserved.
______________________________________________________________________________ SUMMARY INTRODUCTION ............................................................................................................................................ 4 SAFETY AND WARNING.............................................................................................................................. 5 APPLICATION..............................................................................................................
SUBTREX______________________________________________________________________________ INTRODUCTION Congratulation on the purchase of your new LSS loudspeaker. Quality innovation and versatility, this is a summary of the new system developed by LSS for professional sound users. LSS produces professional audio products – the result of exceptional engineering and meticulous craftsmanship. This manual is intended for use with LSS loudspeaker.
______________________________________________________________________________ SAFETY AND WARNING IMPORTANT! SAFETY WARNING! In the interest of their own and others' safety and to prevent voiding the warranty, we recommend a careful reading of this section before using the product. - This product was designed and manufactured to be used as a speaker system in the context of a typical sound reinforcement system.
SUBTREX______________________________________________________________________________ APPLICATION LSS's SUBTREX loudspeaker is a reflex subwoofer used as an extension module for low-frequency reinforcement of TREX system, indeed, both SUBTREX and TREX have the same enclosure cabinet. This system uses two woofers of 15" with high performance and very high peak output for concert sound. SUBTREX powering mode is only passive amplified operation with external digital processor.
______________________________________________________________________________ TECHNICAL SPECIFICATIONS PHYSICAL Dimensions mm (±1 mm) [Inches] Weight Kilograms Frequency Response SYSTEM PERFORMANCE Sensitivity (1 Watt @ 1 m) Max SPL Calculated Nominal Input Impedance (Ω) Power Handling (Watt cont. AES) Peak Power (W) Nominal Dispersion (@ -6 dB) Enclosure material Finish MECHANYCAL Grille Connectors Suspension Height 940 [37.01"] Front Width 600 [23.62"] Depth 700 [27.56"] Rear width 700 [14.
SUBTREX______________________________________________________________________________ INSTALLATION AND WIRING SUBTREX can be installed stand alone or in stack configuration, in most cases, with TREX loudspeaker. It must be installed only in vertical position. In the bottom of the case there are two plastic skeeds used as feet to support the sub. If installation is in stacking mode, plastic skeed fit on the recesses placed in the top of the case placed beneath. 8| Operating Manual ver. SUBTREX-EN-1.
______________________________________________________________________________ In addition, it can be installed suspended through the mounting bracket placed inside the case. There is a total of eight brackets inside the case: four in the top and four in the bottom. Each bracket is secured to two adjacent internal side of speaker using two M10 screwbolts. If needed, replace the screwbolts with eyebolts. More detaliled: Two brackets are connected between top and left side of case.
SUBTREX______________________________________________________________________________ In the connection panel there are two Speakon NL4 connectors referred as ‘IN’ and ‘OUT’. IN is the input connector and must be connected to the amplifier, ‘OUT’ is a LINK OUT and can be connected to other systems.
______________________________________________________________________________ WEEE DIRECTIVE WEEE Directive Warning! The product is marked with this symbol which indicates not to discard electrical and electronic equipment via the normal procedure for disposal of household waste. For these products there is a diverse collection system in accordance with legislation that requires proper treatment, recovery and recycling of used products. For more information please contact the appropriate local authority.
SUBTREX______________________________________________________________________________ TROUBLESHOOTING Problem Possible cause (s) Amplifier 1. No Sound Wiring 2. Poor Low Frequency Response Speakers wired outof-polarity 3. Intermittent output such as crackling or distortion Faulty Connection Action Connect a known working test speaker to the amplifier outputs.
______________________________________________________________________________ DIMENSIONS TOP FRONT REAR 70cm 60cm BOTTOM 36cm 94cm SIDE Operating Manual ver. SUBTREX-EN-1.
SUBTREX______________________________________________________________________________ NOTES 14| Operating Manual ver. SUBTREX-EN-1.
______________________________________________________________________________ CONTACT INFORMATION: LSS Advanced Speaker Systems Via On. Longo 53 89024 Polistena (RC) ITALY Tel (39) 966 9321299 – Fax (39) 966 933007 Email: info@lss.it - Internet: www.lss.it Operating Manual ver. SUBTREX-EN-1.