Service manual

Raider Mini 90 (single/double-seat): Service Manual Version：2.0 Feb. 2006
52
5. CHASSIS
5.1 Rear Axle Removal
a) Disassemble the rear Wheel.
b) Remove the cotter pins on the rear wheel axle nut.
c) Remove the axle nut.
d) Block up the rear end of the machine.
e) Remove the rear wheel and hub assembly by sliding off splines of the axle.
f) Remove the chain.
g) Loosen the nuts on the bearing carrier, and remove the bolts.
h) Remove the axle and bearing carriers as a unit.
i) Remove the brake caliper bolt and brake caliper/
5.2 Rear Swing Arm Removal
NOTE: The swing arm, axle and motor can be removed as a unit if needed.
a) Remove the rear. shock.
b) Remove the rear brake caliper, and set it aside.
c) Unplug the brake light wiring from the electrical box.
d) Remove the throttle cable.
e) Remove the bolts from the swing arm pivot
f) Check the buffer rubber bushing for wear;
If there is any wear on the bushing, it should be replaced.
z Please o
p
erate
p
ro
p
erl
y
accordin
g
to the instructions.
Rear Wheel
Rear Wheel Axle
Brake Caliper
Brake Disc Sprocket
Chain
Rear Wheel Hub