Service manual

Raider Mini 90 (single/double-seat): Service Manual Version：2.0 Feb. 2006
51
z Troubleshooting
Turn on the ignition switch
and press the starting
switch; check if there is a
“Kata” sound from the
starting relay switch.
“Kata”
sounds
Connect the electric starter terminal
with the positive terminal of the
battery (a thin wire can’t be used
because of the high currents).
Remove the starting relay
connector; check the wire
connection of the relay coil
(yellow/red).
No “Kata” sounds
---The electric starter connector
is loose or disconnected;
---The starting relay switch is
broken.
The electric
starter is
out of order.
Disconnected
---The starting switch
is broken;
---The yellow/red
wire or green wire
is open;
---The connector is
loose or has poor contact.
Connected
Connect the starting relay connector,
turn on the ignition switch and press
the starting switch; measure the
starting relay voltage at the starting
switch connector [yellow/red(+) and
ground wire(-) ].
No
voltage
Voltage exists
Check the starting relay Normal
Abnormal
Starter runs. Starter doesn’t run.
---The ignition switch is broken;
---The connector is loose or has
poor contact;
---The bundling point of wires is
open.
---The connector is loose
or has poor contact;
---The starting relay
is defective.