Service manual

Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005

5.3 Front & Rear Shocks

The front and rear shocks are oil

dampened units.

They are non-re-build able.

If any oil seepage is noticed, the shock

should be replaced.

5.4 Adjustment of Front Shock

There are 5 adjustment positions on the front shock. The

default position would be set by the manufacture in the

middle (the third position).

Please use a round nut wrench as you adjust the position, the

tension of the shock spring would increase as you turn the

screw left, and decrease as you turn the screw right.

5.5 Front Wheel Replacement

Don’t disassemble the castle nuts when you replace the front

wheels.

It is only necessary to tighten the nuts so that the wheel turns

freely on the axle with the minimum end play. Please tighten

the nuts after replacing the wheels.

5.6 Front Hubs

a) Check the seals for rips or tears, and replace them if any

exist.

b) Remove the bearings with a punch from the opposite side.

c) Inspect the bearings for easy movements;

If any dirt or mud has gotten into them, wash them in the

cleaning solvent and spin with your finger.

Note: Never spin them with the compressed air.