Service manual

Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005
67
G (Green) ∞ 5 - 100 KΩ ∞
4.5.2 Inspection of Regular -Rectifier
a) Inspect if the regulator- rectifier plug contacts well.
b) Measure the resistance value between every regulator- rectifier terminal.
b) If the resistance value between the terminals is unusual, replace the regulator- rectifier.
4.6 Resistor
4.6.1 Resistor Resistance Value Measurement
a) Measure the resistance value between the resistor wire and vehicle body;
If the actual value is in the range of +/- 1Ω value marked on the diagram or the resistor, it’s
normal; if not, it should be replaced.
4.7 Ignition System
4.7.1 Working Principle
The circuit working principle is shown in the picture.
4.7.2 Ignition Timing Inspection
 When the main wiring—sub electric circuit condition is normal, inspect the regulator-
rectifier.
 The CDI ignition system has already been adjusted in the factory, so there is no
need to readjust it. If the ignition function inspection is necessary, take following
steps to inspect
the
igniti
on timing.