Service manual

Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005

c) Remove the other 3 bearings;

d) Assemble the new bearings;

e) Install the driven belt pulley shaft on the left

crankcase;

f) Assemble the oil seal;

g) Assemble the idle gear shaft comp. and

center shaft comp..

 Replacement of Bearing on Transmission Case Cover

a) Inspect the bearing and oil seal on the transmission case cover for wear and damage;

If they are damaged, they must be replaced;

Remove the oil seal;

Drive out the rear gear shaft bearing.

b) Remove the other 3 bearings.

c) Assemble the new bearings and oil seals;

d) Assemble the rear wheel axle comp.;

e) Assemble the fork shaft comp.;

g) Assemble nut M5 and screws;

 When removing or installing the bearing on the left crankcase body, you must use

the s

ecial tool.

Driven bel

pulley shaft

Left

Crankcase

Idle gear comp.

Center gear comp.

Rear wheel axle

Nut M5.

Bolt M5*25