Service manual

Raider-Classic 150 (Oil-cooled&Internal Gearbox): Service Manual (single/ double-seat) EEC Version;3.0 Feb..2005

e) Install the oil filter screen and screen cover, and tighten them.

e) Supply the specified oil to the specified level.

Disassembling Replacing Oil

level

1.0 L 0.8 L

f) Start the engine and run for several minutes in the idle position to make sure there is no oil

leakage.

g) Stop the engine and inspect if the oil level is proper.

3.10.3 Rotary Oil Pump

The oil pump is the critical component of the lubrication system, so it should be maintained

periodically, and should be replaced as a unit if damaged seriously

 Oil Pump Removal

a) Remove the flywheel of the magneto;

Remove the stator coil and trigger winding.

b) Remove the right crankcase cover bolts and right crankcase cover;

Remove the gasket and dowel pins.

c) Remove the starting reduction gear and starting clutch;

Remove the oil pump partition plate positioning bolts and oil pump

partition plate.

d) Remove the oil pump driving gear nut, drive gear and chain.

e) Remove the oil pump positioning bolts and oil pump assembly;