Owner`s manual

RE-1100cc Double-seat buggy Owner’s Manual Version: 3.0 Dec. 2006
45
[B] STARTING THE ENGINE
1. Without pressing on the throttle pedal, insert the ignition key and turn the ignition switch clockwise.
2. Warm up the engine for 2-3 minutes after starting the cold engine。
Note :
1) Immediately after the engine starts, release the ignition switch to prevent damaging the starter motor.
2) Do not turn on the ignition switch while the engine is already running to prevent damaging the starter motor.
3) Do not repeatedly turn on the ignition switch if the engine fails to immediately start. Wait for 10 seconds before
trying again. Next time, try turning the ignition switch with the throttle pedal slightly depressed.
4) In cold weather, warm up the engine for several minutes at idle speed. Then speed up after the operation
temperature is reached.
5) In hot weather, avoid running the engine at idle speed for a long time. It may overheat the engine.
6) Do not leave your buggy alone after the engine is started.
[C] STARTING TO DRIVE
Test the controls to learn how to start, turn and stop.
Operate your Buggy slowly until you have been familiar with it.