Operating instructions

6
E
N
G
L
I
S
H
Dayton
®
Propane Construction
Heater
3VE59C
Dayton Operating Instructions and Parts Manual
Maintenance (Continued)
10. Reconnect lead wires as shown in
the Wiring Diagram (Figure 8).
11. Reassemble base, fan guard and
base lower.
IGNITOR
The only maintenance necessary for
the ignitor is to be sure that the gap
between the electrodes is kept between
.10” and .15”. The ignitor is accessible
through the combustion chamber.
Storage
Always disconnect the
heater from the
propane tanks when not in use.
1. Always store propane tanks in accor-
dance with Chapter 5 of the Standard
for storage and handling of Liquefied
Petroleum Gasses, ANSI/NFPA 58.
Follow all local codes.
2. Replace the plastic caps over the
fittings that were installed when you
originally unpacked your heater.
3. Store the heater in a safe, clean
and dry location. Do not store the
hose/regulator assembly inside the
combustion chamber of the heater.
4. When removing the heater from
storage, always check inside of the
heater for any foreign objects left
by spiders or small animals. Keep
the inside of the heater clean from
foreign objects and combustibles.
Wiring Diagram
Solenoid
Valve
Yellow
White
White
Black
Blue
Condenser
Line Seat
White
Motor
Black
White
Red
White
Yellow
Green
Black
White
Line
Neut
Valve
Ground
Power Cord
Chassis
Ground
Chassis
Ground
Flame Control
High Limit
Switch
on / off
Thermostat
Spark Plug
Orange
If any original wiring as supplied with the heater must be
replaced, it must be replaced with type AWG105°C wire or its
equivalent except as indicated (∗Type SF2-200, ∗∗SGI-250°C)
Green
Chassis
Ground
Black
Back
Pressure
Switch
Figure 7 – Fan Cross Section
Fan
Setscrew
Motor Shaft
Hub
Figure 8 – Wiring Diagram
For Technical Support or Troubleshooting, Call: 1-800-323-0620