Operating instructions

Assembly (Continued)
FOR MODELS 3VE48D AND 3VE49D
ONLY
TOOLS REQUIRED
- Medium Phillips screwdriver.
1. Lift front guard for arrow direction
and make sure that guard’s wedged
portion fits into the slit hole on the
upper housing.
2. Align the holes in upper housing with
two mounting holes on the handle as
shown in Figure 7.
3. Secure handle with screws provided.
4. Insert cord wrap into the rectangle
holes on the supporter and align the
hole on the cord wrap with the
mounting hole on the side cover as
shown in Figure 7.
5. Secure cord wrap with screws
provided.
FOR MODELS 3VE50E, 3VE51E AND
3VE52E ONLY
TOOLS REQUIRED
- Medium Phillips Screwdriver.
- 3/4 inch socket or adjustable wrench
Assembling Handle & Wheel and
Cord Wrap
1. Slide threaded axle through the rear
section of the wheel support frame.
2. Slide one axle bushing on to each side
of the axle. Slide one wheel on to each
side of the axle. Attach one cap nut on
to each side of the threaded axle and
tighten well.
3. Place heater on wheel support frame.
Align the holes on fuel tank flange
with holes on wheel support frame.
4. Position the Handles on top of fuel
tank flange.
Insert screws through handles, fuel
tank flange and wheel support frames
as shown in Figure 8 and attach nut
finger tight after each screw is inserted.
5. Align the hole on the handles with the
mounting hole on the Cord Wrap.
Insert Screws through Cord Wrap,
handles and attach nut finger tight
after each screw is inserted.
6. After all screws are inserted, tighten
nuts firmly.
Do not operate
heater without
support frame fully assembled to tank.
Operation
KEROSENE (1-K)
For optimal performance of this heater,
it is strongly suggested that 1-K kero -
sene be used. 1-K kerosene has been
refined to virtually eliminate contami -
nants, such as sulfur, which can cause a
rotten egg odor during the operation
of the heater. However, #1 or #2 fuel oil
(diesel fuel) may also be used if 1-K
kerosene is not available. Be advised
CAUTION
Handle
Figure 7 – Handle and Cord Wrap
Installation 3VE48D and
3VE49D only
Front Guard
Screw
Side Cover
Supporter
Screw
Cord Wrap
Wedged
Portion
Slit Hole
For Technical Support or Troubleshooting, Call: 1-800-323-0620
®
Models 3VE48D, 3VE49D, 3VE50E, 3VE51E and 3VE52E
Dayton Operating Instructions and Parts Manual
Figure 8 – Models 3VE50E, 3VE51E and 3VE52E Assembly
Front Handle
Hot Air Outlet
Wheel
Cap Nut L
Cap Nut S
Fuel Tank Flange
Nut
Wheel Support
Frame
Flange Screw
Cord Wrap
Screw
Rear Handle
Air Inlet
Threaded Axle
Wheel Bushing
E
N
G
L
I
S
H
5