Owner Manual

2
Please check the carton contains all the
required parts before assembly.
Your carton should contain the following:
1. Vertical post x 1 with plastic cap on one end
2. Crossbar x 1 with plastic cap on both ends
3. Steel bracket x 1
4. Coach bolt and nut (M8 x124mm/4 7/8”) x 1
5. Coach bolts and nuts (M8 x65mm/2 9/16”) x 4
6. Plastic brackets x 2
BEFORE YOU BEGIN
Materials and tools required for preparing
mounting kit foundations:
•
Three 20kg (44lbs) bags of pre-mix concrete
•
Three wooden stakes 25mm x 50mm x 400mm
(1 x 2 x 15 inch)
•
3 lengths of medium cord each 2 metres
(6.5 feet) long
•
1 spirit level (approximately 500mm/1.5 feet long)
Figure 1 Daytek Retractable Clothesline Mounting Kit
4. Prepare remaining pre-mix concrete to a wet
damp mix and backfill the hole level to the
ground.
5. Ensure post is vertical on both sides using a
spirit level (adjust cords as required).
6. Allow 3 days to cure concrete before installing
crossbar.
To install crossbar
1. Position steel bracket between vertical post
and crossbar.
Note: Crossbar side with middle recess must
be facing out.
2. Place M8x124mm bolt in the middle of
the crossbar, through the steel bracket and
the vertical post, then affix nut and tighten
into position.
Retractable Clothesline Mounting Kit
Installation
To install vertical post
1. Mark recommended position and excavate a
hole 250–300mm square x 450mm minimum depth.
2. Prepare a wet damp pre-mix concrete,
approximately 10kg, and backfill the hole
250–300mm from ground level.
3. Place vertical post into the hole in upright
position with plastic cap facing upwards and
tie each length of cord onto 3 equally spaced
stakes on the ground.
Preparing site foundations
Important : Ensure selected position has
sufficient clearance on all sides considering
maximu
m string drying length or required space.
Recommended height position of line from
ground level to crossbar mounting hole is
user height + 100mm
Maximum wall/post to post distance of 7.0 metres.
CROSSBAR
User’s
height
+
100mm
450mm
(1.5 feet)
minimum
250-300mm (10 – 12 inches)
WOODEN STAKE
FRONT VIEWSIDE VIEW
CORD
1m (3.3 FEET)
GROUND LEVEL
Posts must be erected
vertical.
Fill foundation with
3 x 20kg (44lbs) bags of
pre-mix concrete
PLASTIC
BRACKET
STEEL
BRACKET
VERTICAL POST