Owner Manual

LINE TENSIONER
LINE TENSIONER
4. Secure the cord.
Secure the cord into the line
tensioner as shown in the
diagram and trim excess
leaving approximately 100mm
(10cm/4 inches).
Note: The cord will stretch after
initial use. We suggest re-tensioning
the cord after several uses.
Caution: Do not over tension the
cord as you could distort the frame
and put unnecessary strain on the
joint. Refer to diagrams below.
STEP 1. Thread line through tensioner. STEP 2. Pull line tight.
STEP 3. Loop line around
tensioner knob 2-3 times.
STEP 4. Lock line into clip and trim
excess leaving approximately 10cm
(4 inches).
LINE START 2
LINE END 2
LINE END 1
Important: Tension lines with light hand pull
TOP VIEW
LINE START 1
TOP VIEW
TOP VIEW
YOUR DAYTEK A-FRAME CLOTHESLINE IS NOW READY FOR USE.
ASSEMBLY (CONTINUED)
5