Owners manual

ManualsBrandsDaystar ManualsCarKF09124BK

TOOLS NEEDED BILL OF MATERIALS

Part No. Description Qty

M20151 Front Spacer 2

S20150 Stud extenders 6

S10153 10mm Washer 6

S10292 10mm –1.5 lock nut 6

P11153 Thread lock 1

Description Qty

Floor Jack 1

Jack Stands 2

Lug Wrench 1

10mm wrench 1

17mm wrench 1

20mm wrench 1

21mm wrench 1

Torque wrench 1

Pry Bar 1

17. Install the tire/wheels.

18. Lower off the Jack stands and place back on the ground.

19. Wheel alignment is required.

20. Check all bolts/nuts after 500 miles.

Instruction Sheet P20137

2008 Daystar Products International Inc.

www.Daystarweb.com

Tech Support Contact Info

Tech@DaystarWeb.com

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

Avenue

KF09124

FRONT SPACER LIFT 2”

2009 FORD F150 2WD & 4WD

EASY INSTALL KIT

Summary of content (4 pages)

PAGE 1
7. Install the tire/wheels. 18. Lower off the Jack stands and place back on the ground. 19. Wheel alignment is required. 20. Check all bolts/nuts after 500 miles. TOOLS NEEDED BILL OF MATERIALS Description Qty Part No. Description Qty Pry Bar 1 M20151 Front Spacer 2 Floor Jack 1 S20150 Stud extenders 6 Jack Stands 2 S10153 10mm Washer 6 Lug Wrench 1 S10292 10mm –1.
PAGE 2
Thank you for choosing Daystar Products 14. Tighten the lower strut bolt and nut. Daystar recommends a certified technician install this system. In addition to these instructions , professional knowledge of disassemble/reassembly procedures as well as post instruction checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the integrity and/or operating of the vehicle. Please read all the instructions before beginning the installation.
PAGE 3
12. With the ball joint nut installed on the ball joint tighten the upper strut nuts. Installation steps Jack the front of the vehicle in accordance to manufacture recommendation and support with jack stands, so the front two tires are off the ground. 2. Remove the two front tires/wheels. 3. Disconnect the sway bar end links at the top. 1. 13. Reinstall the brake line bracket to the strut tower. 4. Disconnect the brake line from the strut tower.
PAGE 4
Separate the upper ball joint from the spindle. Use a ball joint separator or other suitable tool. 5. 6. 9. Install the spacer lift on top of the strut plate. Remove the 3 upper strut mounting nuts on the top off the strut tower. 10. Push the upper control arm up and push the strut inward and place the jack under the lower control arm and jack up so the strut studs will go threw the strut tower, use the new lock nuts and washers to install the strut. 11.