Established in 1977 KF09105BK / KF09106BK FORD F150 1997 - 2003 COIL SPRING SPACERS KF09105BK KF09106BK www.Daystarweb.com Like Us Watch Us Share Us Follow Us Instruction Sheet: P21250-02 Tech Support Contact Info 2013 Daystar Products International Inc. Tech@DaystarWeb.com Phone: 623.907.0081 Revision: 02 Fax: 623.907.
Introduction is your number one source for Made In The USA quality, Comfort Ride™ leveling kits. Now backed with our exclusive Go Everywhere © Lifetime Limited Warranty (see terms at Daystarweb.com). To assure your safety and proper installation of this product, take a moment to read all instructions and Product Safety Information before trying to install your Daystar® product.
What is Covered? Real Life Use, Off Road & On: Subject to the ter ms, exclusions and limitations herein, Daystar® warrants to the initial retail purchaser that your Comfort Ride™ or Budget Boost™ leveling kit shall be free of defects in material and workmanship for so long as it is properly installed on a single vehicle owned by the initial retail Daystar® purchaser.
Installation Instructions !Warning: Always work with appropriate personal safety gear including safety glasses, gloves and hearing protection if using air powered tools. Begin by inspecting the components & hardware for damage. Then compare components & hardware to the bill of materials for completeness. If anything is missing/damaged, do not proceed with the installation. Please, call Daystar Products (800-5957659) and we will send you the missing of damaged components free of charge.
23. Remove jack stands and lower the truck back on the ground. Remove all jacks and jack stands from under vehicle. Torque the lug nuts to 85 ft.lbs. using an X pattern 24. With the vehicle on the ground cycle the steering wheel side to side and inspect suspension components, brake lines and tires to ensure there are not any clearance issues.
10. Support the lower control arm with jack just touching the arm. This will prevent it from dropping when the ball joint is disconnected. 11. The use of a coil spring compressor is recommended before the following steps are taken. CAUTION: Spr ing will be under extreme compression use caution when removing. 12. Disconnect the upper ball joint from the top of the spindle using the proper tools. Do not hit the ball joint or the threaded end of the ball joint.
