User Manual

KF09050BK Coil Spring Spacer Kit with Stud Extenders & Shocks
1999-2011 F250, F350 – 2WD
www.DaystarWeb.com
Tech Support Contact Info
[e-mail]
Phone: [phone]
Fax: [phone]
841 South 71
st
Avenue
Phoenix, AZ 85043
Instruction Sheet P20449
Page 1 of 2
 2006 Daystar Products International Inc.
Fig. 6
Fig. 5
1. Read complete instructions and check Bill of Materials before
beginning.
2. Raise the front of the vehicle and support the frame so that the front
tires just touch the ground and remove the front tires.
3. Remove the front shocks and the lower sway bar end link attaching
points.
4. Remove the upper and the lower coil spring clamp bolt and nut with
washer. See figure 1 and 2.
5. Force the axle half down so that the coil spring comes loose.
6. Remove the coil spring and the coil spring rubber isolator. See figure
3.
7. Install the corresponding Stud Extensions (if needed) onto the coil
spring lower clamp stud and install the coil spring spacer onto the
coil spring pad. See figure 4.
8. Install the coil spring onto the coil spring spacer and then into the
frame. You may have to use a coil spring compressor. See figure 5.
9. Install the upper and the lower coil spring clamp bolt and nut with
washer. Make sure that the coil spring is seated correctly into the upper
frame. See figure 6 and 7.
10. Reconnect the sway bar end link attaching points.
11. Assemble the bushings, sleeves, and shock boots for the front shock
absorbers. Use the factory hardware at the bottom and the supplied
hardware at the top..
12. Torque all bolts and nuts to factory specifications. Re-torque all bolts
and nuts after 500 miles.
13. Install front tires and remove the jack stands. Lower the vehicle onto
the ground.
14. On the rear, remove the factory shock absorbers but save all
hardware for re-use.
15. Assemble the bushings, sleeves, and shock boots for the rear shocks. Install them using the
factory hardware.
16. It is recommended that you have a front-end alignment.
Bill of
Materials
Part Number Quantity Description
M03299-BK-
01
2 Coil spring spacer
S10559 2 Stud Extension
H7054S 2 Front shock
H7053S 2 Rear shock
BU01004 1 Hardware bag, front shocks
BU01014 1 Hardware bag, rear shocks
NOTE: If your vehicle has factory 2 ½” studs
holding the coil spring onto the axle assem-
bly, you will not need to use the stud exten-
sions.
Fig. 1
Fig. 7
Fig. 4 Fig. 3
Fig. 2