User Manual

ManualsBrandsDaystar ManualsAutomotiveDaystar, Ford F250/350 Polyurethane Body Mounts, fits 1999 to 2017 2/4WD, KF04050BK, Made in America

1999-2018 FORD F250, F350, SUPER DUTY BODY MOUNT

KIT KF04050BK KF04050KV

BLACK POLYURETHANE KEVLAR INFUSED GRAY POLYURETHANE

www.Daystarweb.com Tech Support Contact Info Tech@DaystarWeb.com Phone: 623-907-0081 Fax: 623-907-0088

841 South 71

Avenue, Phoenix, AZ 85043

Introduction

exclusive Go Everywhere© Limited Lifetime Warranty (see terms at Daystarweb.com). To ensure your

safety and proper installation of this product, take a moment to read all instructions and product safety

information before trying to install your Daystar® product. If you have any technical questions after reading

these instructions, we are here to help. Contact us at 800-595-7659.

Product Safety Information

Throughout these instructions, important safety information is generally preceded by one of three

signal words indicating the relative risk of injury. The signal words are as follows:

! WARNING A hazardous situation which, if not avoided, could result in death or serious injury. You

can be seriously injured or killed if you don’t follow instructions.

! CAUTION A hazardous situation which, if not avoided, could result in minor or moderate injury.

You can be moderately injured and also may suffer

property damage if you don’t follow instructions.

NOTICE Careful attention is required to this instruction or operation, but this does not generally

relate to personal injury. Damage to your product or other property may result if you don’t follow

instructions.

Daystar® is your number one source for Made in the USA quality vehicle accessories, backed by our

Summary of content (4 pages)

PAGE 1
999-2018 FORD F250, F350, SUPER DUTY BODY MOUNT KIT KF04050BK KF04050KV BLACK POLYURETHANE KEVLAR INFUSED GRAY POLYURETHANE www.Daystarweb.com Tech Support Contact Info Tech@DaystarWeb.com Phone: 623-907-0081 Fax: 623-907-0088 841 South 71st Avenue, Phoenix, AZ 85043 Introduction Daystar® is your number one source for Made in the USA quality vehicle accessories, backed by our exclusive Go Everywhere© Limited Lifetime Warranty (see terms at Daystarweb.com).
PAGE 2
NOTICE The new polyurethane body mounts in your kit will be a different size than the original mounts that you are replacing. Even though they appear to be a different size, they are the correct size for your truck and will position the cab at the original factory height. Also, the kit contains mounts for all cab styles and not all pieces will be used on your truck. Installation Instructions 1. Read the instructions completely before beginning installation. A floor jack and basic hand tools are needed. 2.
PAGE 3
8. ALL POSITIONS – You will be removing the rubber from the upper mounts and replacing it with new body mounts. (You might have to use WD-40® or something similar to get the rubber to release from the steel sleeve. You can also use a pair of adjustable pliers, one on the metal and one on the rubber, to pull them apart.) Use a wire brush to clean up the metal shells before installing the new mounts. See figures 5 through 9. 9.
PAGE 4
* or Instruction Sheet: P10568 Revision: 4 Revision Date: 02/10/17 Revised by: WC ©2017 Daystar Products International Inc. ©2018 Daystar products international Inc.