User guide

14.Connect the SCSI ribbon connector to the drive.
Note: This connector is designed to fit in only one direction, so be sure to orient the
connector properly. This means that the rib in the SCSI ribbon cable should mate
with the notch in the SCSI connector.
Connecting the SCSI Ribbon
Cable
15.Connect the SCSI power connector to the drive.
Note: This connector is designed to fit in only one direction, so be sure to orient the
connector properly.
Connecting SCSI Power Cable
16.Reinstall Genesis MP’s side door panel by tightening down the four screws.
17.Install any software that came with the SCSI device. If it is a hard drive, use the
software that came with the drive—or the software included with Genesis MP—to
format the drive.
GenesisMP Chapter 3 – Connecting Additional Peripherals
◆ 53
Rib in the SCSI ribbon cable