User guide

Adding SCSI Devices into the Internal 5.25" bay
Genesis MP’s internal 5.25" drive bay supports either 5.25" or 3.5" SCSI devices. This
bay can be used for large hard drives or for removable media devices such as SyQuest
5.25" or 3.5", Iomega Zip or Bernoulli or tape back-up units.
Note: Contact your DayStar Authorized Reseller or DayStar to obtain the bezels with
3.5" or 5.25" openings required for use with removable media drives.
1. Open Genesis MP (loosen the side door panel) by following the easy instructions
listed previously in this chapter. Remember to turn everything off.
2. Put on your anti-static wrist strap.
3. Locate the bezel on the front of Genesis MP between the CD-ROM and floppy drives.
4. Firmly grasping either side of the bezel, carefully pull the bezel away from the chassis.
Removing 5.25" Bezel
5. If you are installing a 3.5" device into the 5.25" bay, you will need a 3.5" to 5.25"
adapter bracket such as the one below. Contact the 3.5" device’s manufacturer or your
DayStar Authorized Reseller if an adapter bracket was not included with the device.
3.5" to 5.25" Adapter Bracket
Chapter 3 – Connecting Additional Peripherals GenesisMP50 ◆