User guide

Chapter 3 – Connecting Additional Peripherals GenesisMP46 ◆
8. Install the bracket on your new nPOWER card by placing the card over the bracket
and reinstalling the four Phillips head screws.
9. Install the combined nPOWER card and bracket into Genesis MP by carefully
aligning the card over the nPOWER slot on the motherboard and then firmly
pushing the card into the slot.
Installing nPOWER Card
10.Continue to support the card and screw the two hand screws on either side of the
nPOWER card bracket into Genesis MP’s chassis.
11.Reinstall Genesis MP’s side door panel by tightening down the four hand screws.
Adding internal SCSI drives
Genesis MP was designed to make it extremely easy for you to add internal SCSI
devices. With its internal Fast SCSI-2 bus, internal SCSI devices can run up to twice as
fast as those connected to the standard external SCSI bus. Genesis MP comes with a 1"
high, 3.5" drive, with active termination, installed into the bottom drive bay.
Standard Configuration
Genesis MP was designed to support both 1" high and 1.6" high, 3.5" SCSI drives.
Because 1.6" high devices take up roughly twice the space of a 1" high device, adding
a 1.6" device blocks two 1" high bays.
One empty 5.25 " bay
Six empty 3.5 " bays
Single 3.5 " hard drive