Instruction manual

3. Note the cable routing and existing anchor points. Carefully clip
the cable ties attaching the Power Switch Cable to other cables
and anchors. Cables are anchored on the inside of the front
panel and at the Genesis MP side wall (accessible through the
3.5˝ drive bay).
4. Remove switch and cable. Switch is removed by squeezing the
sides of the switch housing and pushing it forward.
Reassembly is the reverse of disassembly, with the following
exceptions:
1. Route and dress cables as in original unit. See section Speaker
Cable/LED Cable/Power Switch Cable Routing. Cable routes
behind 3.5˝ drive bay and up to wiring harness area. Carefully
install new cable ties at anchor points.
LED and Cable Assembly
Removal and replacement of the LED and Cable assembly
requires removal of the Genesis MP front panel and motherboard.
Read and understand those procedures before beginning.
LED in front panel.
The LED is located at the left-hand side of the front panel and con-
nects to the motherboard at the lower right hand corner.
To remove and replace the LED:
1. Remove the Genesis MP Motherboard. See section Genesis
MP Motherboard.
2. Remove any 3.5˝ drives installed in the 3.5˝ drive bay.
3. Remove the Front Panel. See the section Genesis MP Front
Panel (metal).
4. Note the cable routing and existing anchor points. See section
Speaker Cable/LED Cable/Power Switch Cable Routing.
Carefully clip the cable ties attaching the LED Cable to other
cables and anchors. Cables are anchored on the inside of the
front panel and at the Genesis MP side wall (accessible through
the 3.5˝ drive bay).
Chapter 4 – Removal and Replacement Genesis MP56 ◆