Instruction manual

9. Plug the new Drive Power/Fan Power Harness into the power
supply harness connector. Dress the cables to match the origi-
nal installation, securing the fan power cable at the chassis sup-
port rail anchor and the three connector drive power cable at
the top right-hand corner of the 3.5˝ drive bay with cable ties.
The remainder of reassembly is the reverse of removal. Perform
operational tests on the Fans, Power Switch, LED, Speaker, CD-
ROM Audio, Floppy Disk and all Hard Drives and other internal
peripherals before returning unit to customer.
Drive Power/Fan Power Harness Routing
The Drive Power/Fan Power Harness is composed of the fan
power cable and three drive power cables which meet at the
power supply drive power plug.
• Two longer drive power cables and the fan power cable are
routed between the 5.25˝ drive bay and the wall of the
Genesis MP. The drive power cables only are routed across
the top of the 3.5˝ drive bay. The drive power cable with
three drive power connectors is tied off to the drive bay near
the top right hand side. The fan power cable ties off to the
anchor on the chassis support rail just above the fans.
• One drive power cable (the short one) provides power to the
5.25˝ drive bay assembly. Make sure this cable is NOT routed
between the 5.25˝ drive bay and the wall of the Genesis MP.
Drive power/fan power routing
Genesis MP Chapter 4 – Removal and Replacement
◆ 53