Instruction manual

6. Holding both sides of the nPOWER card bracket, firmly pull the
bracket away from the chassis to remove the card from the
motherboard nPOWER processor slot.
Removing the nPOWER card
7. Once the nPOWER card and its bracket have been removed
from the chassis, place the unit —with the metal bracket side
face down—on a clean flat surface.
8. Install the replacement nPOWER card and bracket into Genesis
MP by carefully aligning the card over the nPOWER slot on the
motherboard and by also aligning the bracket’s guide posts into
the alignment holes in the chassis. Once the bracket and card
are properly aligned, firmly push the card into the slot.
Installing nPOWER card
9. Continue to support the card and screw the two hand screws on
either side of the nPOWER card bracket into Genesis MP’s
chassis.
10. Reinstall Genesis MP’s side door panel by tightening down the
four hand screws.
Genesis MP Chapter 4 – Removal and Replacement
◆ 37