User guide

Installing Genesis MP Software
Genesis MP requires that specific software be installed in order to
take full advantage of your machine’s capabilities. Your Genesis
MP Conversion ships with this additional software included on a
CD-ROM.
If you wish to install your Genesis MP software onto your drive, or
need to reinstall it, this section describes the steps required for
installation. Consult your Genesis MP Read Me file for a complete
and up to date list of the files that your Genesis MP Installer
places on your hard drive.
Note: You must install the Mac OS (see previous section)
before installing your Genesis MP software.
Performing an Easy Install
1. Turn off Genesis MP.
2. Insert your Genesis MP Boot Disk into the floppy drive and turn
on your Genesis MP.
3. Insert your Genesis MP CD-ROM into the CD-ROM player.
4. Open Genesis MP Installer and click Continue. The Easy Install
window shown below appears.
Genesis MP Easy Install
window
5. Be sure that the drive you wish to install the software on is
selected as the Destination Disk. If it’s not, click Switch Disk
until the correct drive appears.
6. Click on the Install button.
7. The Installer may ask you to locate specific applications on
your hard drive in order to place multiprocessing plug-ins in
their appropriate locations. If you do not own these applications
simply click on the cancel button and these files will be placed
in the applications folder. You can later install these files using
the Custom Install feature of the Installer software.
Genesis MP Chapter 5 – Installing Genesis MP System Software
◆ 87