User guide

Finishing Up
This concludes the Genesis MP Conversion. Before you close the
cover, remember to:
• Install any RAM DIMMs (Genesis MP needs at least one
DIMM to start up)
• Install any VRAM DIMMs (three-slot models only)
• Install any PCI cards
• Check your work and adjust cable routing where necessary
• Make sure no major assemblies are left over (drives, brack-
ets, processor card). Extra screws and drive rails are O.K.
• Ensure you have not left any tools, cable-tie ends or tape inside
Replace the Genesis MP side cover.
Replace side cover
Chapter 4 – Assembling the Genesis MP Conversion 80 ◆