User guide

Attach the blank bezel to the front of the Genesis MP Conversion.
Attach blank bezel
Installing the Hard Disk Drive
Make sure that the main internal drive ONLY is set to SCSI ID 0
and has termination enabled. (All other internal drives must have
termination disabled and have unique SCSI IDs). The procedure
for doing this varies with different drives. A typical drive is shown
below. Termination is enabled with a jumper. Older drives require
resistor packs for termination.
Hard drive termination jumper
(may vary from picture)
If you are unsure of how to configure termination and ID on your
drive, consult the drive manufacturer for more information.
Genesis MP Chapter 4 – Assembling the Genesis MP Conversion
◆ 77