User guide

Motherboard Tray Adjustment
Carefully attach the motherboard to the motherboard tray using only
the LARGE motherboard screws. Consult the photo and diagram
“Motherboard Screws and Standoffs” for placement of the screws.
CAUTION!
Motherboard screws come in two sizes. Using the wrong screw for
a given standoff will destroy the standoff. Make certain that you
are using the correct screws. Consult the photo and diagram
“Motherboard Screws and Standoffs” for detailed information.
CAUTION!
Be very careful not to over-tighten screws landing into Nylon stand-
offs. Nylon standoffs will strip out easily if overtightened.
Replacement of the standoffs is difficult and time-consuming;
proceed carefully!
Gently attach motherboard
Apply gentle-but-firm pressure to the motherboard AND tray as
indicated in the photo below to snug the motherboard and I/O con-
nectors against the gasket on the back wall.
Press to snug motherboard...
Chapter 4 – Assembling the Genesis MP Conversion 54 ◆
∆
!
∆
!