User guide

Remove the PCI bracket (see below: PCI Bracket) if attached, to
make room for installation of the motherboard.
Get the LED cable out of the way for the time being by poking it
into the fan cage.
IMPORTANT!
Remember to pull the LED cable back out of the fan cage once
the motherboard has been installed.
Use fan cage to hold LED cable
out of the way of motherboard
Mounted on the motherboard tray are several standoffs, some
made of nylon and some made of metal. The motherboard mounts
to these standoffs, and attaches with screws.
Depending upon whether you are assembling a three-slot or a six-
slot conversion, there may be two or more threaded metal studs
protruding from the motherboard tray. These are not used, but do
not need to be removed.
Locate the
large standoffs - you will attach the motherboard to
these standoffs for the motherboard tray adjustment.
Detail of motherboard tray
showing metal and Nylon stand-
offs, empty studs, tray screws.
Chapter 4 – Assembling the Genesis MP Conversion 50 ◆
∆
!