User guide

Genesis MP Chapter 4 – Assembling the Genesis MP Conversion
◆ 49
Prepare the Motherboard Tray for the Motherboard
The motherboard tray is the large metal tray which holds the moth-
erboard, the drive bay fans and the PCI bracket.
The motherboard tray will need to be adjusted with your mother-
board in place. Before you can proceed, you need to make sure
the motherboard tray can move freely to accept the adjustment,
and that there is room to install the motherboard.
The motherboard tray. Circles
indicate 6 adjustment screws
Slightly loosen the six screws which hold the motherboard tray in
place. The holes for the six screws are slotted to provide room for
adjustment.
Make sure there is room to slide the tray forward and back in the
Genesis MP Conversion case. If the tray will not move towards the
rear of the machine, check to make sure the tray is not hitting one
of the blank PCI slot covers. Adjusting the PCI slot cover will pro-
vide the needed clearance.
Adjust PCI slot cover to provide
clearance to move tray