User guide

Chapter 4 – Assembling the Genesis MP Conversion
48
You will probably find it easiest to place the unit flat on its right
side for most of the assembly procedure.
Place case flat on work surface
Remove the packing tape which holds the various cables to the
motherboard tray.
Remove packing tape
NOTE:
One cable has two zip-ties (each with a cable anchor) partially
installed. This is the nPOWER 3.3v power cable. Take care not to
tighten the zip-ties or expose the adhesive backs of the cable
anchors yet. They will be installed after the motherboard and the
nPOWER card are in place.
Cable anchors will be installed
after motherboard is in place
!