User guide

Chapter 3 – Disassembling the Power Macintosh 7500 or 7600 Genesis MP34 ◆
Set the prop support so that it clicks into the hole in the case.
Set the prop
NOTE:
The prop prevents the drive bay/power supply carrier from tipping
back into the case. However, if you pick the 7500/7600 case up
with the drive bay/power supply carrier open, the carrier will tip
outside of the case. If possible, leave the 7500/7600 flat on a table
for the duration of the disassembly.
Remove the Processor Card
Remove the processor card by pulling it straight up and out of the
7500/7600 motherboard. Remove any installed PCI cards at this time.
Set aside PCI cards for re-use. The processor card is not re-used.
Remove the processor card
∆
!