Remote Dashboard and Ethernet Configuration Guide TM Version 1.3.8 INCLUDING REMOTE DASHBOARD APPLICATION IN STALLATION IN STRUCTIONS FOR DAYSEQUERRA MAM, M2 AND M4 MONITORS WITH ETHERNET PORTS DaySequerra │ 154 Cooper Rd. Building 902 │ West Berlin, NJ 08091 │ Voice 856‐719‐9900 │ www.daysequerra.
Remote Dashboard Application Removal Version 1.3.8 supersedes and replaces all earlier DaySequerra Remote Dashboard versions. If you have an earlier version on your PC, please follow these instructions before installing the new version: 1. Using the Windows Uninstall Utility, uninstall the old DaySequerra Remote Dashboard software. 2. Delete the link from the “All Programs” list in your Windows Start Menu. 3. Delete any shortcut you may have created from your Desktop. 4.
Remote Dashboard Application Installation Note: If you have not yet registered your unit please email DaySequerra at support@daysequerra.com to register your unit and receive your password. From CD: 1. Place disk in your PC’s CD drive. 2. Installation should start automatically, if not • Click on “Start” > “My Computer” • Right click on your CD Drive • Select Autoplay 3. You will be notified "You are about to install DaySequerra Remote Dashboard V1.3.8". • Click "OK" 4.
Ethernet – IP Configuration WARNING! Do not attempt to configure your unit over the Internet yourDaySequerra unit. or on an Ethernet network! Network traffic may corrupt your unit.
STEP 2 – Log In Ethernet Configuration Guide 5
STEP 3 – Website and Firmware 6 Ethernet Configuration Guide
STEP 4 – Telnet Configuration Ethernet Configuration Guide 7
STEP 5 – Changing IP Address Close web browser window to exit DaySequerra Telnet module configuration.
Figure 1.0 Controls and Buttons Station – Left Box contains the current band and frequency Right Box contains the call letters for the current station HD Locked – will be displayed if there is an at least one HD frequency detected and locked Band – switch between AM and FM bands by selecting the appropriate button Tuning – manual tuning of the current station using the UP and DN buttons. 200 kHz spacing in FM; 10 kHz spacing in AM Presets – store 50 preset or stored AM or FM stations.
Enable Preset Scan – will allow you to scroll through all of your stored preset stations. Enter the time in seconds that you would like to remain on each station in the Dwell box. NOTE: The Preset stations that are stored in the Remote Dashboard application are NOT the same presets that are stored on your DaySequerra unit.
Figure 2.
Figure 3.
