User guide

18"
M4.2Si User Manual
Alarms Tab
• Alarm configuration – Enable/Disable RF Carrier Loss, OFDM Lock Loss, Audio Loss,
and Multicast Loss. Alarm conditions are set with pull down windows. Sliding the
switch to the left side will ‘ENABLE’ the alarm with the set conditions. Orange switch
indicates the alarm is enabled.
• Relay Outputs – are available for each alarm to be set to a specific relay output. A pin-
out of the GPIO DB-15 is available on page 11 of this user manual.
Alarm Settings
Alarm relay outputs via GPIO
Figure 14.