Vermont 24V User Manual
About Daymak Daymak is one of Canada’s largest Alternative Vehicle providers. We design, engineer, manufacture, import and repair everything from recreational dirt bikes, go-karts and electric golf cars to alternative transportation solutions such as e-bikes and gas scooters. Our electric bicycles represent an energy-efficient and eco-friendly alternative for people who need to get around the city. They greatly increase the practicality of bicycle transportation in urban centres.
Table of Contents Introduction......................................................................................................................................................4 Recharging Your Battery ..............................................................................................................................5 Maintenance........... .........................................................................................................................................6 Technical Specs.
Introduction By making the decision to use an electric bike you are helping to safeguard our environment by saving our planets precious and not adding to carbon pollution. Thank for choosing this electric bicycle. Our bikes are manufactured under rigorous control to the most stringent European and UAS safety standards and are constantly spot checked both here and in the factory.
To preserve the life of each charge always set off and climb hills using 1:1 ped al assist rather than the twist throttle. 2.3 Do not expose the bicycle or battery package to fire, extreme heat sources or alkaline substances. 2.4 When leaving your bicycle during hot weather always try to leave in a shaded well ventilated area. 2.5 For best results always recharge the battery at room temperature. 2.
5. Maintenance and adjustments 5.1 Do not attempt to open the casing of the battery, motor, or regulator or all warrantees will become void. If you experience a problem contact our service department. 5.2 Wheel spokes should be adjusted after 6 months. Handlebar and saddle tubes should never be on the nuts positioning the handlebar, handlebar vertical tube, bicycle saddle, saddle tube and front wheels is 18NM. The minimum torque on the nuts on the pedal bearing axle and rear wheel is 30NM. 5.
. Technical specifications & performance General specifications Type Max speed Net weight Max range Carrying load Wheelbase Dimension Traveling noise Battery specifications Electric bicycle 30km/h 25.0kgs 60km 100kgs 1100mm 150*26*77cm <60db Energy consumption per 100km Problem Top speed too slow Cell type Capacity Rate voltage Main Controller specifications <1.2kw/h Reasons for problem Trouble shooting 1. low battery voltage 1. recharge battery fully 2. handlebar control problem 2.
9. Repair or replacement of components Only use this product in accordance with this user manual. We offer a limited warrantee of on the following items. 9.1 Welds on the main frame, front forks, splashboard, or wheel rims. Two years 9.2 Gears, bearings, motor shell, hub motor. Two years 9.3 Handlebar controls, brakes (excluding rubber brake shoes), controller, charger, or battery capacity. One year 9.4 Paintwork (excluding deliberate damage or scratching) Six months 9.
