User manual

Charging your E-ATV

Charging your e-ATV is a simple process. You require the following:

 •Thechargerthatcamewithyoure-ATV.

 •A110Vhouseholdelectricaloutlet.

Charger Warning

Only use the chargers that were supplied with your e-ATV. Using chargers that do not have

specications identical to those which came with the e-ATV could irreparably damage

your e-ATV’s battery and electrical systems, and may cause injury.

To charge your e-ATV, follow these steps:

1. Turn o the e-ATV and remove the key from the “ignition.”

2. Plug the female end of the charger cable into the charging slot on the e-ATV.

This is found on the outside casing of the e-ATV, in front of and just underneath

the seat.

3. Plug the male end of the charger power cable into your wall socket. This should

be a110v household electricity supply. You can also use a portable generator, if

necessary, but make sure it provides 110V current.

4. Allow the e-ATV’s battery to charge for the appropriate amount of time (6-12

hours).

5.DisconnectthechargerwhentheLEDlightonthechargerisgreen.Thebatteries

have been fully charged.

Ifyourcharger’sLEDstatuslightdoesnotchangefromredtogreenoveranextended

period of time, for perhaps more than 14 hours, and the battery is very hot, the battery or

chargermayneedreplacing.StopchargingandbringbothtoyourDaymakdealerimme-

diately. Do not charge the battery.