User Manual

19
Display advanced
To access the advanced sengs of your display press and hold the + and - buons. To exit
this menu press and hold (+) and (-) buons again. To switch between menus quick press
the (M) buon. To change the seng on any P Menu press (+) or (-) to go up or down
respecvely.
P01: Back light Display Brightness - level 1 is the darkest and level 3 is the brightest.
P02: Mileage unit - Switch between KM and miles.
P03: Voltage - Set the voltage of the bike [this should be set to the number specied in the
specicaon secon].
P04: Sleep me - this species how long before the bike automacally turns o [0 will not
turn o, 1 - 60 how long before it will turn o in minutes].
P05: Pedal Assist Seng - Species how many levels of Pedal Assist there is :
0 = 1 - 3 Levels / 1 = 1 - 5 Levels
P06: Wheel Diameter - This is to set the wheel diameter of the bike to ensure correct
speed and distance travelled accuracy.
P07: Magnec Steel Velocity - Measures the speed of magnets. (1 - 100)
P08: Speed Limit: Sets the maximum speed the unit can travel. (This must be set to your
municipal laws)
P09: Throle on Zero: This determines if the throle will work on 0 Pedal Assist Seng.
0 = Throle works on No PAS / 1 = Throle only works on Level 1 PAS and above.