Specifications

ww w. daxib.c om
INSTALLATION GUIDE DAX-8216C
i
02 03
04
01
07 08 09
05
06
Handwheel
Screw
Handle Core
Clamp Ring
Space Ring
Sub-escutcheon
Rubber Washer
Locking Washer
Locking Nut
Inlet Valve
M5 screw
Basin Deck
Outlet
Outlet
Faucet Body
Rubber Wahwer`
Locking Nut
Rhombic Nut
Protection Sheath
Set Screw
T ee Pipe Coupling
Lift Rod Knob
Upper Lift Rod
Lower Lift Rod
O-ring
Washer
Connecting
Nut
Connecting
Rod
O-ring
Clamping Screw
Cold water inletHot water inlet
Unscrew the M5 screw. Remove the handwheel,
screw, handle core, clamping ring, space ring and
sub-escutcheon from two inlet valves. And screw
the locking nut to the bottom.
Remove the Place faucet body through the basin
deck. Pad the rubber washer and locking washer.
Tighten the rhombic nut with set screws. Then
install the tee pipe coupling. protection sheath,
rhombic nut, locking nut and rubber washer from
the faucet body.
Tighten the locking nut and clamping screws in
order. Then reinstall the handle core, screw and
handwheel in turn and x with M5 screw. Connect
the lift rod with drainage.
Connect two inlet valves and tee pipe coupling
with connecting rod. Tighten the connectiong nuts.
Connect the upper lift rod and the lower lift
rod. Put the lift rod knob into the slot on
the back of faucet body to connect with the
upper lift rod.
After installation, run water for inspection.
The gure is for the case when the handle
is turned on.
Rotate the aerator to adjust the water way
according to your needs, the maximum is ±8°.
Remove the protection sheath, rhombic nut,
locking nut and rubber washer from the faucet
body.
Place two inlet valves through the basin
deck. Keep two outlets of valve body
towards each other. Screw on the sub-
escutcheon. Put on the space ring and
clamping ring, x them.