Specifications

ww w. daxib.c om
INSTALLATION GUIDE DAX-8273C
i
0201 03
04
07
05
08
06
09
Handwheel
Screw
Handle Core
Space Ring
Clamp Ring
Handle Escutcheon
Sub-escutcheon
Rubber Washer
Locking Washer
Locking Nut
Inlet Valve
M5 Screw
Basin Deck
Outlet
Outlet
Faucet Body
Rubber Washer
Locking Washer
Rhombic Nut
Protection Sheath
Tee Pipe Coupling
Set Screw
Lift Rod Knob
Upper Lift Rod
Lower Lift Rod
Ø16 O-ring
W asher Connecting NutØ 16 O-ringConnecting Rod
Clamping Screw
Drainage
Turn on hot water
Turn on cold water
Unscrew the M5 screw. Remove the
handle, screw, handle core, plastic space
ring, clamp ring, handle escutcheon and
sub-escutcheon from two inlet valves.
And screw the locking nut to the bottom.
Place faucet body through the basin deck
hole. Pad the rubber washer and locking
washer. Tighten the rhombic nut with set
screws. Then install the tee pipe coupling.
Tighten the locking nut and clamping
screws in order. Then reinstall the plastic
space ring, handle core, screw and
handwheel in turn and x with M5 screw.
(Make sure that the handle printed sun
mark is installed on the left and the
handle wtih snow mark is installed
on the right.)
Connect two inlet valves and tee pipe
coupling with connecting rod. Tighten the
connecting nuts.
After installation, ow water for inspec-
tion. The gure is for the case when the
handle is turned on.
Remove the protection sheath, rhombic
nut, locking washer and rubber washer
from the faucet body.
Place two inlet valves through the basin deck.
Keep two outlets of valve body towards each
other. Put on the sub-escutcheon and handle
escutcheon. Fix them with clamp ring.
Connect the upper lift rod and lower lift rod.
Put the lift rod knob into the slot in the back
of faucet body to connect with the upper lift
rod.
Connect the lift rod and drainage.