Specifications

ww w. daxib.c om
INSTALLATION GUIDE DAX-478-CR
01
02 2A
2B 03
04
You should clean all the dirts from valve
outlets. Turning off the water supply valves.
This is usually found near the water meter. If
you are replacing an existing faucet, remove
the faucet from the sink and clean the sink
surface thoroughly.
Install without Deck Plate. Make sure the
O-RING is placed onto the bottom of Base
Ring. Install faucet through hole in sink. From
underside sink, put Plastic Washer and Moun-
ting Nut. Position faucet on sink properly and
tighten Mounting Nut.
Install with Deck Plate. Place a bead of plum-
ber’s putty between faucet and sink. Place
Deck Plate over the three holes of sink. From
underside sink, tighten Wing nut.
Make sure the O-RING is placed onto the
bottom of Base Ring. Install faucet through
Deck Plate. From underside sink, put Plastic
Washer and Mounting Nut. Position faucet on
sink properly and tighten Mounting Nut.
If necessary, tighten screws using a adjustable
wrench until the faucet is rmly connected to
the sink.
Connect hot and cold water supply lines to the
Water Supply Valves.