D AX - 478- B N KITCHEN FAUCETS SERIES
Max 1-3/4” 4-7/8” 6-1/4” 6-7/8” D AX - 478- B N 7-5/8” FEATURES • • • • • • • • • Pull out shower head Brass body casting Dual sprayer ABS shower head Ceramic cartridge Flow rate 1.
T E C H N I CAL S P E CI F I CAT I O N D AX - 478- B N KITCHEN FAUCET DAX-478-BN MODEL DAX-478 ADA Y UPC APPROVED Comply ANSI APPROVED Comply ASME APPROVED Comply WATERSENSE CERTIFIED N/A NSF APPROVED Y CONNECTION SIZE 9/16” FAUCET HOLE SIZE 1-3/8” FAUCETS HOLE 1 FAUCET TYPE Pull out FLOW RATE (GPM) 1.
I N S TAL L AT I O N G U I D E D A X - 478- B N 01 You should clean all the dirts from valve outlets. Turning off the water supply valves. This is usually found near the water meter. If you are replacing an existing faucet, remove the faucet from the sink and clean the sink surface thoroughly. 2B Make sure the O-RING is placed onto the bottom of Base Ring. Install faucet through Deck Plate. From underside sink, put Plastic Washer and Mounting Nut.
I N S TAL L AT I O N G U I D E D A X - 478- B N 05 06 07 Open Clos e Ho t Cold After installation is complete, remove Spray head and rotate handle to the close position. Turn Water Supply Valves on, and check all connections for leak. Flush faucet by running hot and cold water in full position for one minute. 08 Attach Weights to the pull-out hose using screws at the proper point of the hose. Be noted Weights are optional. Lift the handle up, the cartridge will be activated allowing water to flow.
PA R T L IST 1 A Faucet 2 B Spray Head 3 C Flexible Hoses(3) 4 D Pull-out hose 5 E Mounting Nut 6 F Weight(1) + Screw (2) 7 G Brass Adaptor + Back Pressure Valve 8 H Allen Wrench 2 1 3 4 5 6 7 8 CS@daxib.
