Instructions / Assembly

ASSEMBLY INSTRUCTIONS (INSTALLATION)
NOTICE: Please use caulk in the back plate and wall
mounting surface to prevent water from entering.
STEP 6
Attach the fixture to mounting unit through screw holes as shown,
and secure it with screws.
STEP 7
Install bulbs (not included).
STEP 3
Place the top cover onto the threaded pipe, then secure with
rubber ring A and nut.
STEP 4
Attach the iron to the fixture through screw holes as shown,
and secure it rubber ring B and decorative nut.
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Then, connect the positive, negative and
ground wires with the supplied wire nuts. Secure with electrical tape.
STEP 5
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)